Read 125 Physics Projects for the Evil Genius Online
Authors: Jerry Silver
– solar cell
– insulated wire (you need two 15-inch lengths with the insulation removed)
– wire stripper (a pen knife or a pair of scissors will do)
– ammeter (if you have a multimeter, configure it as an ammeter)
– soldering iron with (resin core Pb/Sn) solder
– a third hand (or a second person to help solder)
Figure 81-1
Light sensor. Courtesy PASCO
.
1. Position the light bulb, so a few meters are in front of it without obstruction.
2. Turn off the room lights.
3. Pick a location such as about 25 cm from the light bulb and take a reading on the light meter. (This starting distance is arbitrary and depends on the sensitivity of the meter you are using.)
4. Record the distance (any choice of unit, inches, or meters can work, but be consistent throughout your investigation). Record the light intensity, as shown in
Figure 81-2
, in the units in which the light meter is calibrated (such as lumem/m
2
lm/m
2
).
Figure 81-2
Courtesy PASCO
.
Expected Results5. If you are using the solar cell, orient it so it is perpendicular to the line between you and the source of light; the unit of measurement will be in amps. Be careful not to block the front of the solar cell with your fingers, which can compromise the accuracy of your reading.
The farther away you get, the less intense the light becomes.
The rate of drop-off is not linear. The farther away you get, the faster the light intensity falls off.
More specifically, the light intensity drops off as the inverse-square of the distance. This is shown graphically in
Figure 81-3
.
Figure 81-3
Courtesy PASCO
.
Light intensity is related to the distance from its source according to the equation:
I = I
o
/r
2
where
I
represents light intensity at distance,
r
, between the light source and the point of measurement for an initial intensity, I
o
.
A similar inverse square law relationship can be found with a source of sound and a sound intensity meter.
Light intensity drops off as the inverse square of the distance from the source of light.
Sir Isaac Newton was definitely no slouch when it came to physics. And, if you asked Newton whether light was a wave or a particle, he would say it was a particle. Newton was actually correct for reasons that would not become clear until several centuries later. Thomas Young proved the opposite was true—that light was (also) a wave. Today, we recognize that light has
both
particle and wave-like behavior. We re-create Young’s experiment in this project to explore light’s wave-like behavior. Young observed the effect of light emerging from two small slits in an opaque plate. Instead of two slits, you create a similar effect using a diffraction grating which lets you explore the effect of dozens of openings.
– Edmunds 3001307 13,500 lines/inch
http://scientificsonline.com
– PASCO OS 9127 600 lines/mm (15,000 lines/inch)
http://store.pasco.com
– Frey Scientific 1559099721 15,000 lines/inch
http://www.freyscientific.com
Figure 82-1
Apparatus used for this project
.
A pattern of spots is produced to the right and left of the center line. These are the result of the constructive interference of waves. This proves that light is a wave. Or, more accurately, in addition to having particle-like properties, light is also a wave.
If the distance to the screen is increased, the distance between the bright spots also increases. The distance between the laser and the diffraction grating should not matter, however, because the light strikes the diffraction grating in a perpendicular direction, regardless of how far it is coming from.
When waves meet, if the crests occur at the same time, the waves add. This is called
constructive interference
. If when waves meet a crest and trough come together, the waves cancel. This is called
destructive interference
.
Interference is a basic characteristic of waves. The light- and dark-spot pattern is the result of interference of the waves emerging from two adjacent openings in the diffraction grating.
Once you locate the first order bright spots, you can try to locate the second, third, and possibly higher order lines. This may require a very dark room.
This project recreates one of the most significant experiments of the twentieth century in which Thomas Young demonstrated that light is a wave. Interference patterns are a unique characteristic of waves. Because light in this experiment exhibits an interference pattern, it proves conclusively that light is a wave.